
24 MAG816 - Installation and Operation Manual
Sounders Enable/Disable
To disable the sounders:
• Press
button: DISABLE/ ENABLE LED blinks.
The ZONE 1 LED blinks in yellow (2 blinks
per second) if ZONE 1 is enabled and
lights permanently if ZONE 1 is disabled.
• Press
button until you
reach the last zone in the
system - 8, 12 or 16.
• Press
button once again: The SOUNDER FAULT/ DISABLE LED
will start blinking.
• Press
button: The SOUNDER FAULT/ DISABLE lights
up permanently.
• Press
button to exit the
sounder disabling mode: That will initialize the start-up procedure
and introduce the changes (item 6.1).
At this point the sounders are disabled.
You can exit the sounder disabling mode also by pressing the
button, as in that
case the procedure for initial start-up will not run.
To enable the sounders:
• Press
button: DISABLE/ ENABLE LED blinks.
The ZONE 1 LED blinks in yellow (2 blinks
per second) if ZONE 1 is enabled and
lights permanently if ZONE 1 is disabled.
• Press
button until you
reach the last zone in the
system - 8, 12 or 16.
• Press
button once again: The SOUNDER FAULT/ DISABLE LED
lights up permanently in yellow.
• Press
button: The SOUNDER FAULT/ DISABLE will
start blinking.
• Press
button to exit the
sounder enabling mode: That will initialize the start-up procedure
and introduce the changes (item 6.1).
At this point the sounders are enabled.
You can exit the sounder enabling mode also by pressing the
button, as in that
case the procedure for initial start-up will not run.
Komentáře k této Příručce