ESP DIGI-VIEW 4 System Uživatelský manuál stáhnout pdf (Strana 5)

3.2.1. Configure the host's network settings

If the Linux host machine has a known and configured IP address, skip this step.

The host computer’s IP address may be unknown (if the address was obtained through a DHCP server) or

unassigned. To obtain or assign an IP address for the host computer open a console and execute the

command ifconfig.

Check whether there is an IP address for the eth0 network card. If it is, write it down. If not, set one

provided by your network administrator by editing the file /etc/network/interfaces (it might be a different

file in other Linux distributions):

iface eth0 inet static

address 192.168.42.1

netmask 255.255.255.0

gateway 192.168.42.1

Configuring the host computer's network settings requires

Administrator privileges. If running Digi ESP from the LiveDVD,

enter an empty password for the root.

3.3. Keyboard layout

If Digi ESP is running from the LiveDVD or was installed without specifying a keyboard layout, the English

keyboard layout is established by default. To change the keyboard layout on the host computer, go again

to System Settings and on the Personal section click Regional & Language.

Then click on Keyboard Layout and select the appropriate regional keyboard layout from the list.

1 2 3 4 5 6 7 8 9 10 ... 29 30

Žádné komentáře

ESP DIGI-VIEW 4 System Uživatelský manuál Strana 5