ESP MP-600 Specifikace stáhnout pdf (Strana 22)

SECTION 3 Installation

ESP-600C Plasma Power Source -

3-4

NOTICE

3.4.2 Input Conductors

• Customer supplied

• May consist either of heavy rubber covered

copper conductors (three power and one

ground) or run in solid or flexible conduit.

• Sized according to the chart.

Input conductors must be terminated with

ring terminals.

Input conductors must be terminated with ring

terminals sized for ½" hardware before being

attached to the ESP-600C.

3.4.3 Input Connection Procedure

1. Remove left side panel of the ESP-600C

2. Thread cables through the access opening in

the rear panel.

3. Secure cables with a strain relief or conduit

coupling (not supplied) at the access opening.

4. Connect the ground lead to the stud on the

chassis base.

5. Connect the power lead ring terminals to the

primary terminals with supplied bolts, washers

and nuts.

6. Connect the input conductors to the line (wall)

disconnect.

Chassis Ground

Power Input Cable

Access opening

(rear panel)

Primary

Terminals

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 119 120

Žádné komentáře

ESP MP-600 Specifikace Strana 22